In 2010, the Nanhai District People's Government and the Hong Kong University of Science and Technology signed an agreement to establish a research and development center for LED and flat panel display (FPD) engineering technology in Nanhai. After more than two years of construction, the center has more than 20 well-known R&D teams, and has six high-end experiments including failure analysis, reliability testing, board-level assembly pilot, chip packaging pilot, material preparation and testing, and photoelectric thermal performance testing. room.
The semiconductor lighting and flat panel display industry is an emerging industry that is closely cultivated and developed in the South China Sea. It is the first LED-FPD engineering technology research and development center set up by the Hong Kong University of Science and Technology in the Pearl River Delta region. On the basis of the cooperation and construction of the engineering center, the Nanhai District People's Government and the Hong Kong University of Science and Technology have also signed a memorandum of cooperation on cooperation. Explore new areas such as photoelectric display, energy conservation and environmental protection, and new materials, and build a new mechanism for transfer and transformation of results. At the same time, it will establish an internship and entrepreneurial base for Hong Kong students in the South China Sea, establish a training base for technology and management talents at the Hong Kong University of Science and Technology, and jointly promote the industrialization of scientific and technological achievements of the Hong Kong University of Science and Technology and the industrial development of the South China Sea.
EDM (electrical discharge machining), is a manufacturing process used to obtain a specific desired shape in metal by applying electrical discharges(sparks),When it comes to using electrical discharge machining, the water serves as a key component. To get the best performance from an Edm Machine, the water must be kept as clean as possible. During the EDM process, some of the metal goes into the water as small particles. The water is filtered and deionized(demineralized) in order to remove those metal atoms. Deionized water helps to promote a higher metal removal rate and enhances the machine`s capacity to deliver a more precise cut. So the EDM water filter is very important component for EDM water filtration system.
Edm Filter,Edm Machine,Edm Machining,Wire Edm Machine
Donguan Bronco Filter Co., Ltd , https://www.broncofilter-cn.com